Interior and Exterior Painting in Knoxville, TN
Walls, ceilings, trim, doors, siding, shutters, feature walls and even worn bathroom floor tile, painted by Ryan Curtis and prepped before the first coat. Serving Knoxville, Farragut, Oak Ridge and Maryville.
/filters:strip_exif()/filters:no_upscale()/media/3e566dcb-e15c-48b2-8540-990ff5299096.jpeg)
What painting work does Curtis Can Do LLC do in Knoxville?
Curtis Can Do LLC paints inside and outside homes in Knoxville, Farragut, Oak Ridge and Maryville. Ryan Curtis does the work himself, from the first walkthrough to the final touch-up. Inside, that means walls and ceilings, trim and doors, crown molding and board-and-batten feature walls, plus cabinets when the walkthrough shows they are a good fit. Outside, it means siding and trim, shutters, and stain on decks and fences. We have also primed, painted and stenciled worn bathroom floor tile as a budget refresh. Most of a good paint job happens before the first coat: moving and covering, patching, caulking, sanding and priming. We do that part carefully, then cut clean lines and roll the finish coats. Colors and products are talked through at the walkthrough, so you know what is going on your walls.
- The person who walks the house with you is the person holding the brush
- Furniture, floors and fixtures covered before any sanding or patching
- Cleanup and a touch-up walk before we call a room done
/filters:strip_exif()/filters:no_upscale()/media/9f42b4a0-20c8-4983-a143-cf42a7f05162.jpeg)
Rooms, trim, exteriors and a few surprises
Nine kinds of painting work, from a single accent wall to the outside of the house. Not sure where yours falls? Describe it and we will sort it out at the walkthrough.
Walls and ceilings
- Bedrooms, living rooms, hallways, kitchens and stairwells
- Ceilings cut in clean where they meet the wall
- Drywall patches primed so they do not show through
- Color changes, repaints and fresh coats on tired walls
/filters:strip_exif()/filters:no_upscale()/media/35686a41-589c-4d7d-b963-9a6b97d5f41d.jpeg)
Trim and doors
- Baseboard, window and door casing, interior doors
- Glossy old trim sanded so new paint grips
- New trim primed and painted after install
- Smooth, even finish on doors, edges and frames
Crown molding
- Crown painted to match or contrast with the trim
- Gaps caulked so the line reads clean at the ceiling
- Cut in tight against both wall and ceiling
- Pairs well with new trim or carpentry work
Board-and-batten feature walls
- Wall built and painted as one project
- Paint color chosen to suit the room and light
- Nail holes and seams filled before the finish coats
- A popular way to give a plain wall some depth
Cabinets (ask at the walkthrough)
- Not every cabinet is a good candidate for paint
- We look at the boxes, doors and existing finish first
- Doors and drawer fronts prepped, primed and painted
- If it is not a fit, we tell you plainly
Exterior siding and trim
- Loose paint scraped and bare wood spot-primed
- Gaps and joints caulked before painting
- Trim, fascia and doors painted to hold up outside
- Soffit and other exterior repairs can be paired with the paint
/filters:strip_exif()/filters:no_upscale()/media/ef4888b6-6366-4b36-b555-45680ea6ec19.jpeg)
Shutters
- New or existing shutters primed and painted
- Color chosen against the siding and front door
- Front porch and entry trim painted to match
Decks and fences (stain)
- Stain applied to decks, railings and fences
- Surface cleaned and dry before the stain goes on
- Boards, fasteners and rails checked as we work
- See deck building and pressure washing for the full chain
Worn bathroom floor tile
- Paint and stencil refresh for sound tile
- A budget update instead of tearing the floor out
- Photos below: old gray tile to white, then stenciled
- Cracked or loose tile is replaced, not painted
Old gray bathroom floor, painted and stenciled
A budget refresh for tile that is still sound. These photos come from one of our own bathroom jobs: the worn gray floor first, then the painted white result and the stenciled pattern.
/filters:strip_exif()/filters:no_upscale()/media/5a058e42-609d-4d00-a5b9-12bf66b03e0d.png)
/filters:strip_exif()/filters:no_upscale()/media/141f83ed-1ae8-4ba6-8e70-761b36cb21d4.png)
/filters:strip_exif()/filters:no_upscale()/media/08e82e7d-d662-485c-8223-4f48dd6ce80a.png)
/filters:strip_exif()/filters:no_upscale()/media/3dd9b9cc-05d8-4eac-8712-8c842b1a52bf.png)
We check the tile first. Cracked, loose or water-damaged tile should be replaced instead of painted. For a full bathroom rebuild, see bathroom renovation.
A room, a porch or a fence that needs paint?
Tell us what you have. We answer Monday to Friday, 9 am to 5 pm, and set up a walkthrough.
The work that happens before the first coat
Paint hides very little. Dents, gaps, stains and gloss show through new color. This is the checklist we follow on a typical interior room.
- Move and coverFurniture is moved or grouped and covered. Floors, stairs and the path through the house are protected before any dust is made.
- Patch drywallNail pops, dents, cracks and old anchor holes are filled, sanded smooth and spot-primed so patches do not show through.
- Caulk gapsGaps along trim, crown, baseboard and window casing are caulked so the lines read clean and sharp.
- Sand glossy trimOld glossy paint is scuffed so new paint can grip. Rough spots and drips from earlier coats are sanded down.
- Prime stains and new drywallStains, bare wood and new drywall get primer first. It seals the surface so the finish coat goes on even.
- Cut linesWe cut in at ceilings, corners and trim by hand, so the edges are crisp before the roller goes on the open wall.
- Two coats where neededWhere color, coverage or a repair calls for it, the room gets a second coat. We check the surface in good light.
- Cleanup and touch-up walkTape comes off, drop cloths come up and the room is cleaned. We walk it with you and touch up anything that is not right.
/filters:strip_exif()/filters:no_upscale()/media/053830f3-04ec-4dfb-b17a-ffd298da3806.jpeg)
Interior and exterior painting side by side
The brush strokes are similar. The prep, the timing and the surfaces are not.
| Interior painting | Exterior painting | |
|---|---|---|
| What gets painted | Walls, ceilings, trim, doors, crown molding, board-and-batten feature walls and, at the walkthrough, cabinets. | Siding, trim, fascia, doors and shutters, plus stain on decks and fences. |
| Prep | Move and cover, patch drywall, caulk gaps, sand glossy trim, prime stains and new drywall. | Wash off dirt and mildew, scrape loose paint, sand rough spots, spot-prime bare wood, caulk joints, repair rot or damaged boards first. |
| Timing and weather | Not tied to the weather, so it can go ahead in any season. Drying time between coats depends on the product and the room. | Depends on the weather. Paint and stain need dry surfaces and mild, dry stretches. In East Tennessee, rain and humidity can push exterior work around, so we plan it with the forecast. |
| Surfaces to watch | Fresh drywall patches, stains, glossy old trim, humid rooms like bathrooms and kitchens. | Peeling paint, soft or rotted wood, sun-faded south and west sides, shaded areas where mildew grows. |
| Products | Paint type, sheen and primer are discussed at the walkthrough, matched to the room and how it is used. | Exterior paint, primer and stain are discussed at the walkthrough, matched to the surface and the side of the house. |
Scroll the table sideways on a small screen. Specific products are confirmed at the walkthrough.
From walkthrough to touch-up
Five steps, in the order they happen. Ryan handles each one.
Walkthrough
We look at the rooms or the exterior with you. We note surface condition, colors you are considering, trim, ceilings and anything that needs repair first.
Plan the colors and products
We talk through paint type, sheen and primer, and confirm scope, schedule and price in plain terms before work starts.
Prep the surfaces
Furniture is covered, surfaces are patched, caulked, sanded and primed. For exteriors, that includes washing and scraping.
Paint
Lines are cut in by hand, then coats are rolled or brushed on. A second coat goes on where color or coverage needs it.
Cleanup and touch-up walk
Tape and covers come up, the area is cleaned, and we walk the work with you to touch up anything that is not right.
/filters:strip_exif()/filters:no_upscale()/media/1ebb41ed-c981-4f01-b02f-67e7b813e096.jpeg)
What moves the cost of a painting job
We do not quote numbers over the phone. These are the things that change the price, and we confirm them at the walkthrough.
- Size and number of rooms. More wall and ceiling area, or a bigger exterior, means more time on site.
- Interior or exterior. Outside work adds washing, scraping, weather planning and often ladders.
- Condition of the surfaces. Peeling paint, stains, cracks and rough drywall all need more prep before painting.
- Trim, crown and details. Lots of trim, crown molding, doors and tight cutting takes more hand work than open walls.
- Color changes. Going from dark to light, or covering a bold color, can call for primer and extra coats.
- Height and access. Vaulted ceilings, stairwells and second stories need more setup.
- Repairs and add-ons. Drywall patching, carpentry, board-and-batten builds or exterior repairs are added to the scope.
- Cabinets, stain and specialty work. Cabinet painting, deck and fence stain and stenciled tile each have their own prep and steps.
Painting in Knoxville, Farragut, Oak Ridge and Maryville
Curtis Can Do LLC is based in Farragut and paints homes in four Tennessee towns.
- Knoxville
- Farragut
- Oak Ridge
- Maryville
East Tennessee summers are humid and many lots are shaded, so mildew and peeling paint show up on siding, trim and decks. Inside, older homes often have glossy trim, patched walls and bathrooms that need paint made for damp rooms. We look at each house first, then recommend the prep and products that fit.
Painting questions, answered
What affects the cost of a painting job in Knoxville?
Room count and size, surface condition, how much trim and crown there is, color changes, height and access, and any repairs all affect the price. Exterior jobs add washing and weather planning. We do not quote by phone. At the walkthrough we look at the surfaces, then confirm scope and price in plain terms before starting.
Do you paint both interior and exterior?
Yes. Inside we paint walls, ceilings, trim, doors, crown molding and feature walls. Outside we paint siding, trim and shutters, and stain decks and fences. Ryan Curtis does the work himself. Tell us which parts of the house you are thinking about and we can plan one project or several.
Do you paint cabinets?
Sometimes. Not every cabinet is a good candidate for paint, so ask at the walkthrough. We look at the boxes, doors, drawer fronts and the current finish, then tell you plainly whether painting makes sense. If it does, doors and fronts are prepped, primed and painted. If not, we explain what else could work.
How do you prep a room before painting?
We move and cover furniture, protect the floors, patch drywall, caulk gaps and sand glossy trim. Stains and new drywall get primer. Then we cut in the lines and roll the finish coat, adding a second coat where color or coverage calls for it. We finish with cleanup and a touch-up walk with you.
Can you paint over worn bathroom floor tile?
When the tile is sound, yes. We have primed and painted old gray bathroom floor tile white and added a stenciled pattern, as shown in the photos above. It works as a budget refresh. We check the tile first, since cracked, loose or water-damaged tile should be replaced instead of painted.
When can exterior painting be done in East Tennessee?
Exterior paint and stain need dry surfaces and dry stretches of weather, so rain and humidity can move the schedule around. We plan around the forecast and confirm timing at the walkthrough. Interior painting does not depend on the weather, so it can usually go ahead in any season.
Do I need to move furniture before you start?
Not all of it. Small items, art and fragile things are best moved by you ahead of time. We group the larger furniture in the room and cover it, and we protect floors and stairs. Tell us at the walkthrough about anything heavy or delicate, and we will plan around it.
How do I get started with a painting project?
Use the Get a Quote button or call during business hours, Monday to Friday, 9 am to 5 pm. Tell us which rooms or which part of the exterior, what you want changed, and send photos if you can. We will set up a walkthrough to look at the surfaces and confirm scope and price.
Ready to paint?
Tell us about the rooms or the exterior. We answer Monday to Friday, 9 am to 5 pm, and will set up a walkthrough.